[LargeFormat] How do I get off the list?
LNPhoto
largeformat@f32.net
Fri Jan 16 09:14:04 2004
According to Accuweather.com today's high for Hell (Michigan) is 16=B0F
On Friday, January 16, 2004, at 02:03 AM, Jim Hemenway wrote:
> Tori:
>
> I guess you're right:
>
> It was so cold here last night, that after I had put my Christmas Tree
> out to be collected, it dragged itself back into the garage.
>
> Here in Winchester, it's so cold that I just put a bucket of boiling=20=
> water outside and it froze so fast that the ice was still hot.
>
> I was talking to Stuart and our conversation froze in mid-air. We had=20=
> to take the ice indoors and melt it so we could hear what we were=20
> talking about.
>
> Then the light rays from the sun froze above the clouds and we had to=20=
> get into the freezer to get warm.
>
>
> Tori Nelson wrote:
>
>> Jim, Jim, Jim, I know it's cold where you are, and you can't go out=20=
>> and play, but really, it's not nice to tease a brother photographer. =20=
>> Tsk, tsk, tsk!
>> Joe, don't listen to Jim. All you have to do is click your heels=20
>> together three times, and each time, repeat the phrase, "There's no=20=
>> place like home."
>> Just do this and you'll magically go back to where you came from. =20
>> Simple, really.
>> Tori
>> On Thursday, January 15, 2004, at 08:02 PM, Jim Hemenway wrote:
>>> Joe:
>>>
>>> Here's how to unsubscribe:
>>>
>>> First, ask your Internet Provider to mail you an Unsubscribing Kit.
>>>
>>> Then follow these directions.
>>>
>>> The kit will most likely be the standard no-fault type. Depending on
>>> requirements, System A and/or System B can be used. When operating=20=
>>> System A, depress lever and a plastic dalkron unsubscriber will be=20=
>>> dispensed through the slot immediately underneath. When you have=20
>>> fastened the adhesive lip, attach connection marked by the large "X"=20=
>>> outlet hose. Twist the silver- coloured ring one inch below the=20
>>> connection point until you feel it lock. The kit is now ready for=20
>>> use. The Cin-Eliminator is activated by the small switch on the lip.=20=
>>> When securing, twist the ring back to its initial condition, so that=20=
>>> the two orange lines meet. Disconnect.
>>>
>>> Place the dalkron unsubscriber in the vacuum receptacle to the rear.
>>> Activate by pressing the blue button. The controls for System B are
>>> located on the opposite side. The red release switch places the
>>> Cin-Eliminator into position; it can be adjusted manually up or down=20=
>>> by
>>> pressing the blue manual release button. The opening is self-=20
>>> adjusting.
>>>
>>> To secure after use, press the green button, which simultaneously=20
>>> activates the evaporator and returns the Cin-Eliminator to its=20
>>> storage position. You may log off if the green exit light is on=20
>>> over the evaporator . If the red light is illuminated, one of the=20
>>> Cin-Eliminator requirements has not been properly implemented. Press=20=
>>> the "List Guy" call button on the right of the evaporator . He will=20=
>>> secure all facilities from his control panel.
>>>
>>> To use the Auto-Unsub, first undress and place all your clothes in=20=
>>> the
>>> clothes rack. Put on the velcro slippers located in the cabinet=20
>>> immediately below. Enter the shower, taking the entire kit with you.=20=
>>> On the control panel to your upper right upon entering you will see=20=
>>> a "Shower seal" button. Press to activate. A green light will then=20=
>>> be illuminated immediately below. On the intensity knob, select the=20=
>>> desired setting. Now depress the Auto-Unsub activation lever. Bathe=20=
>>> normally. The Auto-Unsub will automatically go off after three=20
>>> minutes unless you activate the "Manual off" override switch by=20
>>> flipping it up. When you are ready to leave, press the blue "Shower=20=
>>> seal" release button. The door will open and you may leave. Please=20=
>>> remove the velcro slippers and place them in their container.
>>>
>>> If you prefer the ultrasonic log-off mode, press the indicated blue=20=
>>> button. When the twin panels open, pull forward by rings A & B. The=20=
>>> knob to the left, just below the blue light, has three settings,=20
>>> low, medium or high.
>>>
>>> For normal use, the medium setting is suggested. After these=20
>>> settings have been made, you can activate the device by switching to=20=
>>> the "ON" position the clearly marked red switch. If during the=20
>>> unsubscribing operation, you wish to change the settings, place the=20=
>>> "manual off" override switch in the "OFF" position. You may now make=20=
>>> the change and repeat the cycle.
>>>
>>> When the green exit light goes on, you may log off and have lunch.
>>>
>>> Please close the door behind you.
>>>
>>> Joe Levine wrote:
>>>
>>>> How do I get off the list?
>>>> How do I get off the list?
>>>> How do I get off the list?
>>>> How do I get off the list?
>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> LargeFormat mailing list
>>> LargeFormat@f32.net
>>> http://www.pairlist.net/mailman/listinfo/largeformat
>>>
>>>
>> Tori Nelson
>> ASMP/San Diego Board Member
>> http://www.torinelson.com
>> 858-945-0071
>> _______________________________________________
>> LargeFormat mailing list
>> LargeFormat@f32.net
>> http://www.pairlist.net/mailman/listinfo/largeformat
>
> --=20
>
> Jim - http://www.hemenway.com
>
>
> _______________________________________________
> LargeFormat mailing list
> LargeFormat@f32.net
> http://www.pairlist.net/mailman/listinfo/largeformat
>