[LargeFormat] Pins for Reducing Back
Les Newcomer
largeformat@f32.net
Sun Jul 27 18:12:26 2003
I've just used the proper diameter nail, drill the hole slightly
smaller (so it won't split) and drove it in. then I took a dremel tool
and rounded/polished the head so it looked like a pin and didn't slice
my finger open. I suppose you could use a needle bearing roller, it
would be polished and hardened.
Les
On Sunday, July 27, 2003, at 01:07 PM, Benno Jones wrote:
> I found a 4x5 back for my B&J 5x7 flatbed but it only has the pins
> that fit
> into the metal fittings on one side. Any idea where I can find these
> little
> guys or what would make a good substitute?
>
> Thanks,
> Benno Jones
>
>
> _______________________________________________
> LargeFormat mailing list
> LargeFormat@f32.net
> http://www.pairlist.net/mailman/listinfo/largeformat
>