[LargeFormat] Film holder question

[Alan Davenport]

At 08:23 AM 12/2/2002 -0800, you wrote:
>Does anyone have a method for tightening the dark slide locks on Fidelity
>holders.  I have four or five holders where the locks spin so freely that I
>am concerned about yanking out a dark slide when I pull the holder out of
>the back.

An old trick to tighten old screws in wood, is to remove the screw and
put a piece of toothpick or similar sliver into the hole, then replace
the screw.  As small as the holes and screws are in the locks, you might
try this with a (very thin!) strip of paper.  It won't take much...